Tribological Performance Of The Head Disk Interface In Perpendicular Magnetic Recording And Heat Assisted Magnetic Recording

International Data Corporation (IDC) estimates that hard disk drives will still be the main storage device for storing digital data in the next 10 years, holding approximately 80% of the data inside data centers. To increase the areal density of hard disk drives, the mechanical spacing between the head and disk surface has decreased to approximately 1nm. At such a small spacing, tribology of the head-disk interface, including head-disk contacts, wear, material buildup, and lubricant transfer, become increasingly more important for the reliability of hard disk drives. In addition to small spacing, heat-assisted magnetic recording (HAMR) technology aims to deliver higher areal density recording by heating up the media surface to a few hundred Celsius degrees, facilitating the writing process. High temperature at the head and disk surfaces cause serious reliability issues for the head-disk interface (HDI). Therefore, understanding of the main factors that affect the reliability of the head-disk interface is an essential task. In this dissertation, the effect of bias voltage and helium environment on the tribological performance of the head-disk interface is investigated. To do this, we first simulated the flying characteristics of the slider as a function of bias voltage in air and helium environment. Thereafter, an experimental study was performed using custom built tester located inside a sealed environmental chamber to study the effect of air and helium on wear and lubricant redistribution at the head-disk interface during load-unload. We investigated the effect of bias voltage and relative humidity on wear, material buildup, and nano-corrosion on the slider surface. Finally, we have studied laser current and laser optical power in heat-assisted magnetic recording as a function of operating radius, head-disk clearance, media design, and their effects on the life-time of the head-disk interface. The results of this dissertation provide guidance for the effect of bias voltage, relative humidity, and helium environment on wear, material buildup, corrosion, and lubricant transfer at the head-disk interface. More importantly, our experimental study in heat-assisted magnetic recording leads to a better understanding of the main factors that cause failure of the HAMR head-disk interface. Our results are important for the improvement of the tribological performance and reliability of perpendicular magnetic recording (PMR) and heat-assisted magnetic recording (HAMR) head-disk interface.